Validation des protocoles de décontamination des surfaces contamin´ées par le 18F-FDG `a l’aide d’un d´etecteur `a puits NaI (Tl)
Loading...
Files
Date
Journal Title
Journal ISSN
Volume Title
Publisher
Université Sétif 1 Ferhat Abbas. Faculté des Science
Abstract
This study was conducted within the framework of operational radiation protection at the PROFAM OSM radiopharmaceutical production facility (Biopharm Industrie, Oued Smar, Algiers), where 18F-FDG is produced using a GE PETtrace 800 cyclotron. The primary objective was to validate a surface decontamination protocol tailored to the specific constraints of short-lived radiotracer production environments.
The experimental approach involved a comparative evaluation of several surface materials (stainless steel, glass, plastic, and wood) subjected to controlled 18F contamination and subsequently decontaminated using a standardized Radiacwash®-based protocol. Residual activity levels were measured with a NaI(Tl) CAPRAC-t detector, with radioactive decay correction applied systematically to all measurements.
Statistical analysis was performed using a one-way ANOVA with surface material as the single factor, followed by Tukey’s HSD post-hoc test. Results demonstrate that surface material is a determining factor in decontamination efficiency, with wood differing significantly from all other substrates due to its porosity and high absorption capacity. This work contributes to the establishment of reference decontamination levels consistent with Algerian regulatory requirements (COMENA) and Good Manufacturing Practice guidelines (GMP/PIC-S), and provides practical recommendations for surface
contamination management in controlled areas.
